![]() Directly from within the active PCB document using the File » Fabrication Outputs » Gerber Files menu command.Output is generated when the configured output generator is run. Using a Gerber output generator in an OutputJob Configuration file (*.OutJob).Gerber output can be generated in one of two ways: The Gerber Setup dialog provides you with tools to completely configure your Gerber file output options. It is advisable to consult with your board fabricator to confirm their requirements before supplying the output documentation required to fabricate your design. Parent page: WorkspaceManager Dialogs SummaryĮach Gerber file corresponds to one layer in the physical board – the component overlay, top signal layer, bottom signal layer, the solder masking layers and so on.
0 Comments
Leave a Reply. |